Removing The Temporary Stand - Sharp PN-655RU Mode D'emploi

Removing the Temporary Stand

Prepare wall-hanging brackets or a stand to mount the monitor unit. Read the manual for the brackets
or stand for the proper mounting procedure. (The screw holes for mounting brackets (M10 x 4 holes) are
provided on the rear of the monitor.)
Caution
• The monitor is heavy. It must be handled by three or more people.
• This monitor is fi xed to the temporary stand when shipped from the factory. Please note that this stand is for
temporary use only until the monitor is properly mounted.
1. Hold the monitor with the handles to prevent
it from falling down, and remove the stand
fi xing screws (4).
2. Lift the monitor by holding it with the handles
and the underside of the unit.
3. When the installation is complete, attach the
included stand hole protection covers, using
the supplied screws.
(1) Remove the screws from the monitor
unit.
(2) Secure the stand hole protection covers
with the screws removed in step (1).
• The temporary stand is specifi cally designed for this monitor. Do not use for other devices.
16
E
Screws Screws