Publicité
Les langues disponibles
Les langues disponibles
Operation
of the unit, this includes different
combinations of colours of the
flame base and media lighting.
! NOTE: The last theme of the
cycle is a prism where the unit
cycles through a variety of colours.
Pressing the
cycling and holds the unit on the
preferred color, indicated by a "U"
- Unfreeze or a "F" - Freeze on the
display.
G.
Brightness
Changes the brightness of the
lights in the unit.
→ Adjusted by repeatedly pressing
the corresponding button on the
remote.
• Indicated by the second digit on
the Floating Display™ changing
to show: "H" (high), and "L" (low).
H.
Sleep Timer
The Sleep Timer can be set to
automatically shut off the fireplace
after a preset time (from 30 minutes
to 8 hours).
→ To set the timer press the timer
button on either the remote or the
unit, repeatedly, until the desired
time is displayed.
• The On Screen Display will
display the different times as it
is adjusted. Once the timer has
begun, pressing the
button stops the
button
will display the time remaining
before the unit turns Off.
! NOTE: The Sleep Timer can be
cancelled at any time by pressing
the
button repeatedly until the
sleep timer displays nothing.
Resetting the Temperature
Cutoff Switch
Should the heater overheat, an
automatic cut out will turn the
heater off and it will not come back
on without being reset. It can be
reset by unplugging the unit and
waiting 5 minutes before plugging
the unit back in.
Remote Control Battery
Replacement
1. Slide battery cover open on the
remote control.
2. Correctly install one 3 Volt
(CR2032 [longer life] or CR2025)
battery in the battery holder.
3. Close the battery cover.
Battery must be recycled or dis-
posed of properly. Check with your
Local Authority or Retailer
for recycling advice in your
area
17
Publicité
