Publicité
Les langues disponibles
Les langues disponibles
Fireplace Installation
Figure 3
Key-hole
Permanent
mounting hole
pressure on the partially
reflective
fireplace upright and slightly
forward to allow the partially
reflective glass to fall out of
the inside framing.
• Remove partially reflective
glass from fireplace.
4. Position the fireplace on a wall
at the position where it will be
mounted (Figure 3).
bubble level (one is supplied)
to ensure that fireplace is level
on the wall.
5. Mark the location of four (4)
screw locations on the wall
(through key-holes).
CAUTION: If installing unit on
a wall that is constructed of
drywall ensure that appropriate
Wall stud
glass,
tilt
Use a
wall anchors are used and at
least one is located into a stud.
6. Remove fireplace from wall
and store in a safe place away
from traffic.
7. Screw all four (4) supplied #8,
3.8 cm square head mounting
screws
the wall and/or wall anchors
leaving 6.5 mm of thread.
8. Align chosen key-holes with
screws and hang fireplace
on the wall.
and washers will fit through
the
keyholes and fireplace will
slide down into place (screws
will slide into narrow part of
key-holes).
9. Tighten all four (4) mounting
screws down on fireplace
chassis.
10. Screw the two (2) supplied
#8
through two of the permanent
mounting holes which align
with a wall stud.
11. Carefully replace and install
partially reflective glass and
glass brackets using screws
from step 1.
12. Refer
Installation section, for final
installation procedures.
and
washers
Screw heads
square
head
to
Front
into
screws
Glass
Publicité
