Jennair JB36NXFXLE Guide D'installation page 24

3. Using the installation block as a guide for depth, fasten the
shoulder washers with the hex-head pointed screws into the
predrilled holes marked with a blue "L."
A. Move shoulder washers from Hole R to Hole L.
B. Move mounting bracket.
4. Peel back the film cover on the door panel in the area of the
brackets and shoulder washers only. Do not fully remove the
film covering until the installation is complete.
Custom Wood Panels - Predrill Panels
IMPORTANT: The custom panel template shipped with the
refrigerator can be used for either a 3/8" (0.95 cm) or
a 1/8" (0.32 cm) reveal installation.
The drilling templates are used only for custom wood overlay
■
panels.
The drilling templates are double-sided.
■
The drilling holes are precut into the template.
■
1. On the template, locate the diagram of your refrigerator. Then,
follow the letters and colored arrows to place correctly the
drilling template on the back side of the panels.
NOTE: Check the direction of the arrows to determine which
holes to mark when the template is aligned at the top of the
panel and which holes to mark when the template is aligned at
the bottom of the panel.
2. Predrill pilot holes into the wood rails bordering the doors and
top grille panels.
Custom Wood Panels - Prepare Panels
Door Panels
IMPORTANT: This step is complete on JennAir Stainless Steel
Panel Kits.
1. Place panels on a firm, covered, flat surface with the front
facing down.
2. Locate the 2 predrilled holes in the handle side edge of the
door panel.
24
A
A
B
3. Using the installation block as a guide for depth, attach a
shoulder washer with a hex-head pointed screw
(both provided with refrigerator) into the predrilled door panel
(2 per door).
A. Shoulder washer and hex head pointed screw
B. Installation block
4. For the mounting bracket, insert the hex-head pointed screws
(provided with refrigerator) into the wood holes at the top of
the door panels where they were predrilled.
NOTE: It is critical to use the 5/8" screw, the longest length
provided, to attach the bracket to the top of the door panel.
A
A. U-shaped hole
B. Slot
5. Attach a panel top bracket to the top edge of the door panel(s)
by placing the large ends of the keyhole slots over the screws
and sliding the bracket so that the screws are centered in the
slots.
NOTE: Start with the screws in the center of the slots as
shown, then move the door panel, as necessary, to align.
A
A. Door panel
B. Mounting bracket
A
B
B
B