Starting Up / Before Using For First Time - SOLIS CREMA SL 70 Mode D'emploi

SOLIS CREMA SL 70
3.0 Starting up
3.1 Fill the water container with
cold water up to a maximum of 3 lit-
res. Insert it into the rear of the appli-
ance and press home firmly so that the
base valve opens. Close the cover.
Note: Use only fresh cold water to fill
the container. Do not use mineral
water, milk or any other fluid.
3.2 Pull the required length of
cord out from the back of the
appliance. Leave the rest in the spe-
cial cable compartment. Connect the
appliance to an earthed socket.
3.3 Turn the main switch to ON.
The appliance must now be vented
and rinsed out.
Note: The best time to remove air from
the appliance is when it is cold. For
this reason, start the venting operation
as quickly as possible after switching
on.
50
3.4 Vent the appliance.
To do this, place a large container
under the hot water/steam nozzle, turn
the rotary knob and activate the pump
switch until a steady stream of water
comes out of the nozzle. Let it run until
about 2 dl of water has been collected,
then close the rotary switch and turn off
the pump switch again. The applian-
ce has now been vented.
3.5 Rinse the appliance out. To do
this, fit the empty filter holder and place
a cup underneath. Turn the pump
switch on until the cup is full. Turn
the switch off again. The appliance
has now been rinsed out.
3.6 The appliance is ready to ope-
rate when the temperature light
shows green. We recommend leaving
the empty filter holder in place while the
appliance is heating up so that it is pre-
warmed.
User's manual