Before Using; General Information; Safety Advice; Installation - SOLIS OhEspresso 112 Mode D'emploi

Before using

Please read the following instructions carefully. They
contain important information about operating and
caring for your appliance, as well as about safety.
We recommend you retain these notes for future
use.

1. General information

– Before connecting the appliance, check that the
voltage indicated on the appliance information
plate matches your mains voltage.
– Always clean the appliance with a dry or at most
a slightly damp cloth.
– All repairs must be carried out by approved
service centres (e.g. SOLIS Customer Service).
Non approved repairs pose a risk for the user.
– No liability for any damage or injury can be
accepted if the appliance is used or operated
in any way that does not conform with these
instructions, or if an unapproved repair is carried
out. All warranty claims will also be invalid.
– Protect the appliance from frost; do not leave
overnight in the car in winter as this may dam-
age your machine.

Safety advice

– Never operate the appliance with a defect
power cord.
– Never operate the appliance without the coffee
E
wast container, without water or without the
drip tray and cup grille.
– Only use original SOLIS-1,2,3 SPRESSO coffee
portions. Normal coffee portions may damage
the appliance, in which case no liability can be
accepted. All warranty claims will also be invalid.
– Never unplug the appliance by pulling on the
cord; never handle the plug with wet hands.
– Never immerse the appliance in water.
– Children do not realise the risks associated with
electrical equipment – never leave children
unsupervised with electrical appliances.
16

2. Installation /

Before first use
2.1 Open water tank cover (9), remove water tank
(3), fill with cold water and replace.
Replace water tank cover.
2.2 Set coffee selector (4) to position 0.
2.3 Set the ON/OFF switch (5) to position I. Wait
until the operating temperature indicator
(6) shows green.
2.4 Insert an original SOLIS-1,2,3 SPRESSO coffee
portion in the opening provided and place a
coffee cup under the coffee outlet.
2.5 Turn the coffee selector (4) from position 0 to
position I and allow cup to fill. When full, turn
the coffee selector back to position 0. The used
coffee portion will automatically fall into the
coffee waste container when switch is returned
to position 0. The first coffee you make when
using your appliance for the first time will
«clean» your factory-new machine and should
not be drunk.
3. Making coffe
Note: This appliance will only function with original
SOLIS-1,2,3 SPRESSO coffee portions.
3.1 Open water tank cover (9), remove water tank
(3), fill with cold water and replace.
Replace water tank cover.
3.2 Check that the ON/OFF switch (5) is in position
I and the operating temperature indicator
( 6) shows green.
3.3 Place an original SOLIS-1,2,3 SPRESSO coffee
portion in the opening provided for this
purpose. Position a coffee cup under the coffee
outlet.
3.4 Turn the coffee selector (4) from position 0 to
position I (Fig.3) and allow cup to fill. When
full, turn the coffee selector (4) back to
position 0. The used coffee portion will auto-
matically fall into the waste coffee container
when coffee selector (4) is returned to
position 0.