Publicité
Les langues disponibles
Les langues disponibles
ACCESS TO USB PORT
If using USB Stick to change Electronic Controls
Settings
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
To Install or Remove USB Stick
USB Port is located on the Display Control Board.
1. Remove 6 crews to allow the Fascia Panel to pull and rotate
outward from collar assembly. Do not discard fascia panel
screws.
2. Disconnect ribbon connector (A). Set fascia panel aside. Do
not discard the fascia panel.
3. Remove three screws from Bracket to allow Display Control
Board and Bracket Assembly to rotate outward from Collar
Assembly. Do not discard screws.
A
4. Rotate Display Control Board and Bracket Assembly
outward to provide access to User Interface Control Board.
5. Install USB Stick into USB Port or remove the USB Stick
from USB Port.
6. Replace Display Control Board and Bracket Assembly with
three screws previously removed.
7. Replace Fascia Panel with six screws previously removed.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
8. Reconnect power and enter the USB Menu; see page 18.
19
Publicité
