Publicité
Les langues disponibles
Les langues disponibles
5. Remove screws at top, bottom, and side of door (5 screws).
6. Holding door over towel, grasp sides of outer door and
gently lift to separate it from inner door. Do not use a putty
knife to pry apart. Do not pull on door seal or plastic door
catch.
7. Be certain to keep cardboard spacer centered between
doors. Reattach outer door panel to inner door panel so
handle is on the side where hinges were just removed.
8. Reattach screws at top, bottom, and side of door (5 screws).
9. Attach door hinges to dryer door so that larger hole is
at the bottom of the hinge and the hinge pin is toward
the door front.
10. Remove the four screws that attach two plugs on the left
side. Attach plugs to right side using the same four screws.
11. Insert screws into bottom holes on left side of cabinet.
Tighten screws halfway. Position door so large end of door
hinge slot is over screws. Slide door up so screws are in
bottom of slots. Tighten screws. Insert and tighten top
screws in hinges.
12. Close door and check that door strike aligns with door
catch. If needed, slide door catch left or right within slot
to adjust alignment.
MAINTENANCE INSTRUCTIONS
Clean lint screen before and after each cycle.
■
Removing accumulated lint:
■
From inside the dryer cabinet:
Lint should be removed every
2 years or more often, depending
on dryer usage. Cleaning should
be done by a qualified person.
From the exhaust vent:
Lint should be removed every
2 years, or more often, depending
on dryer usage.
If dryer does not operate, check the following:
Electrical supply is connected.
■
Circuit breaker is not tripped or house fuse is
■
not blown.
Door is closed. Listen closely to hear the door switch
■
activate.
Cycle selection button has been pushed firmly and display
■
shows cycle time.
IF YOU NEED ASSISTANCE
Contact the dealer from whom you purchased the appliance, or
a Maytag designated service company.
When calling, please know the purchase date and the complete
model and serial number of your appliance. This information
will help us to better respond to your request.
Whirlpool Corporation, Benton Harbor, Michigan 49022, U.S.A.,
Marion Division, 1300 Marion-Agosta Road, Marion, OH 43301
EU representative: Whirlpool EMEA S.p.A.,
Via Carlo Pisacane, 1, 20016 Pero (MI) Italy
13
Publicité
