Decommissioning; Switching Off The Appliance; Taking The Appliance Out Of Service; Disposing Of The Appliance - V-ZUG Ideal 60i Mode D'emploi

Decommissioning

A LED on the bottom rear of the appliance (at the
compressor) flashes repeatedly every 5 seconds*.
→ There is a fault.
Please contact the after-sales service (see 6) .
u
Excessive noise.
→ Due to the various speed steps, speed-regulated* compres-
sors can generate different running noises.
The sound is normal.
u
A bubbling and gurgling noise.
This noise comes from the refrigerant flowing in the refriger-
→
ation circuit.
The sound is normal.
u
A quiet clicking noise.
→ The noise is produced whenever the refrigeration unit
(motor) automatically switches on or off.
The sound is normal.
u
A hum. It is briefly a little louder when the refrigeration
unit (the motor) switches on.
→ Refrigeration increases automatically when the Fast-Freeze
function is activated, fresh food has just been placed in the
appliance or the door has been left open for a while.
This noise is normal.
u
→ The ambient temperature is too high.
Solution: (see 1.2)
u
Vibration noises
→ The appliance is not standing firmly on the floor. As a result
objects and adjacent units start to vibrate when the refriger-
ator is running.
u Check the installation and realign the appliance.
u Keep bottles and jars apart.
The temperature display indicates:
→ There is a fault.
Please contact the after-sales service (see 6) .
u
DEMO shines in the temperature display.
→ The demo mode is activated.
Please contact the after-sales service (see 6) .
u
The outer surfaces of the appliance are warm*.
→ The heat of the refrigeration circuit is used to prevent
condensate from forming.
This is normal.
u
The temperature is not cold enough.
→ The door of the appliance is not properly closed.
Close the door of the appliance.
u
→ Insufficient ventilation.
Keep ventilation grille clear, and clean it.
u
→ The ambient temperature is too high.
Solution: (see 1.2) .
u
→ The appliance was opened too frequently or for too long.
Wait to see whether the appliance reaches the required
u
temperature by itself. If not, please contact the after sales
service (see 6) .
→ The temperature is incorrectly set.
Set the temperature to a colder setting and check after 24
u
hours.
→ The appliance is too close to a source of heat (stove, heater
etc).
Change the position of the appliance or the source of heat.
u
→ The appliance was not inserted properly into the recess.
Check whether the appliance was inserted correctly and
u
the door closes properly.
The internal light does not come on.
→ The appliance is not switched on.
Switch the appliance on.
u
→ The door was open for longer than 15 minutes.
32
to
F0 F9
The internal light switches itself off automatically after about
u
15 minutes if the door is open.
→ The LED illumination is faulty or the cover is damaged:
WARNING
Risk of injury due to electric shock!
Live parts are located under the cover.
u Have the LED interior light changed or repaired only by the
customer service or by specialized personnel trained for the
purpose.
WARNING
Danger of injury by LED lamp!
The light intensity of the LED lighting corresponds to risk group
RG 2.
If the cover is defective:
u Do not look into the illumination with optical lenses from the
immediate proximity. This can cause injury to the eyes.
The door seal is defective or needs to be replaced for
another reason.
→ The door seal can be replaced. It can be replaced without
the need for special tools.
Contact Customer Service (see 6) :
u
The unit has iced up or condensation has formed.
→ The door seal may have also slipped out of its groove.
Check to ensure that the door seal is seated properly in the
u
groove.
8 Decommissioning

8.1 Switching off the appliance

u Press On/Off button
approx. 2 seconds.
w A long beep is emitted. The temperature display
is dark. The appliance is switched off.
w If the appliance cannot be switched off, the child
lock function is active (see 5.1) .

8.2 Taking the appliance out of service

u Empty the appliance.
u Switch off the appliance (see 8) .
u Remove mains connector.
u Clean the appliance (see 6.2) .
u Leave the door open to prevent odour.

9 Disposing of the appliance

The appliance contains some reusable materials
and should be disposed of properly - not simply
with unsorted household refuse. Appliances which
are no longer needed must be disposed of in a
professional and appropriate way, in accordance
with the current local regulations and laws.
When disposing of the appliance, ensure that the refrigeration
circuit is not damaged to prevent uncontrolled escape of the
refrigerant it contains (data on type plate) and oil.
u Disable the appliance.
u Pull out the plug.
u Cut through the connecting cable.
* Depending on model and options
Fig. 2 (1)
for