Refrigerator Compartment - V-ZUG Ideal 60i Mode D'emploi

u Confirm by briefly pressing the Quick Cool button
Fig. 2 (2) .
appears on the display.
w c1
u Confirm by briefly pressing the Quick Cool button
Fig. 2 (2) .
Fig. 2 (7) , lights up on the
w The child lock symbol,
display.
flashes on the display.
w c
w The child lock function is switched on.
If the function is to be switched off:
u Confirm by briefly pressing the Quick Cool button
Fig. 2 (2) .
w appears on the display.
c0
u Confirm by briefly pressing the Quick Cool button
Fig. 2 (2) .
flashes in the display.
w c
w The child lock function is switched off.
To end the setting mode:
u Briefly press the On/Off button
w The temperature display shows the temperature again.

5.2 Refrigerator compartment

5.2.1 Food refrigeration
u Store perishable food such as ready-to-serve dishes, meat
products and sausages in the coldest zone. Place butter and
preserves in the upper area and in the door (see 1) .
u Use recyclable plastic, metal, aluminium and glass
containers and cling film for wrapping.
u Always store liquids and food which is subject to odour or
taste transfer in closed containers or cover them.
u Use the front area of the refrigerator compartment floor only
for briefly putting down cooled products, e.g. when rear-
ranging and sorting. However do not leave cooled products
there otherwise they may be pushed back or tipped over
when the door is closed.
u Do not store food too close together to enable good air
circulation.
5.2.2 Setting the temperature
The temperature depends on the following factors:
- the frequency of opening the door
- the room temperature of the installation location
- the type, temperature and quantity of the food
Recommended temperature setting: 5 °C
An average temperature of approx. -18 °C is then established
in the freezer compartment.*
The temperature can be adjusted continually. Once the 1 °C
setting is reached, the sequence starts again at 9 °C .
w The new setting is adopted approx. 5 seconds after the last
time the button was pressed and the set temperature
displayed again. The temperature in the interior gradually
adjusts to the new value.
5.2.3 Quick Cool
Quick Cool selects the lowest cooling temperature. This
gives you colder storage temperatures. Use Quick Cool
to quickly cool large quantities of food.
Quick Cool uses slightly more energy.
Cool with Quick Cool
u Briefly press the Quick Cool button
Fig. 2 (6) symbol lights up on the display.
w The Quick Cool
w The cooling temperature drops to the lowest setting.
Quick Cool is on.
w Quick Cool switches off automatically after 12 hours. The
appliance continues in energy-saving Normal mode.
* Depending on model and options
Fig. 2 (1) .
Fig. 2 (2) .
SwitchingQuick Cool off ahead of schedule
u Briefly press the Quick Cool button
Fig. 2 (6) symbol dims on the display.
w The Quick Cool
w Quick Cool is off.
5.2.4 Tray
Shifting or removing the trays
The trays are prevented from being pulled out accidentally by
pull out stops.
Fig. 3
u Adjust the height of the tray: To do this move the slots along
the supports.
u Lift the tray and pull it out towards you.
u To remove the tray completely, set it at an angle and pull it
out towards you.
u Push the tray back in at the desired height. The removal
stops must point downwards and be positioned behind the
front contact surface.
Disassemble the tray
u The trays can be dismantled
for cleaning.
5.2.5 Using the split tray
u Push the split tray under-
neath as in the illustration
5.2.6 Hang-on trays
Move the hang-on trays
u Remove the hang-on trays as per the illustration
Disassemble the hang-on trays
u The hang-on trays can be dismantled for cleaning.
5.2.7 Using the bottle holder
Control
Fig. 2 (2) .
Fig. 4
29