Publicité
Les langues disponibles
Les langues disponibles
Battery and battery charger
The battery can be used both-sided for optimal counterweight to the punching tool.
No dissimilar batteries may be used in the charger.
The battery as well as the charger must be protected against humidity.
The charger is designed for a voltage of 230 Volt / 50 Hz.
New batteries must be fully charged before first use. For charging the battery put the plug of the charger into to the
power outlet and the battery into the charger. The charging time is approx. 45 minutes.
Do not work with a feeble or partial discharged battery, especially at application with large
diameter, square and oblong punches. The device could stop during the punching procedure
and it could come to damages.
Charge the battery, as soon as the speed of the hydraulic punching unit slows down.
The battery charge level can be read off an LED on the charging unit.
Green:
battery is completely charged
Red:
battery is empty and is charging
Blinking:
battery is not completely inserted or battery is too hot. An acoustic signal sounds.
Do not charge a battery which is partial unloaded.
If you want to charge 2 batteries one after another, wait approx. 15 minutes before you load the
nd
2
battery.
Prod. No. 02071
Prod. No. 02072
16
Publicité
