Publicité
Les langues disponibles
Les langues disponibles
Available hydraulic screws, distance inserts and spacer sleeves
Distance inserts
Prod. No. 02004
Operating time
The device is not suitable for permanent operation. After approx. 40 to 50 punching procedures a break should be
taken of approx. 10 to 20 minutes so the hydraulic punch cools down.
Technical data battery and battery charger
Battery:
Charging time:
Charging cycles:
Use:
Battery charger:
-charges all batteries between 18 up to 28 V
-compatible for NiCad-, NiMH- and Li-Ion-batteries
-automatic temperature control
-the change between quick charges to conservation charging avoids overloading of the battery cells
-the state of charge will be indicated by LED-indication
-the PCB is completely moulded
Special hydraulic
screw
Prod. No. 01395
18 V; 3,0 Ah NiMH
45 min. after complete discharge
~ 500 at normal conditions
0° bis + 40° C, loosing capacity under 0° C
Distanzbuchse
Prod. No. 01396
15
Publicité
