Pioneer PRA-DW11 Mode D'emploi page 10

Installation
7. Fasten the drive 2 mounting fixture
to the DVD-R/RW unit.
÷ Attach the drive 2 mounting fixture
to the DVD-R/RW unit so that the %
mark on the fixture is oriented
toward the front.
÷ Fasten the fixture in place by using
the four accessory flange screws
(black) and tightening in the order
1= 2= 3= 4.
8. Once the mounting fixture has been
fastened to the DVD-R/RW unit,
install the DVD-R/RW unit together
with its mounting fixture to the
DVD recorder PRV-LX1.
÷ Align the two square holes on the
drive 2 mounting fixture with the
tabs on the PRV-LX1, then use the
4 screws removed in step 4 to
fasten the drive in place (fasten
screws in order 1= 2= 3= 4).
②
④
Square holes
10
PRA-DW11
En
Towards
②
①
③
Tabs
front
④
% mark
mounting fixture
9. Attach the IDE cable and power
cable
÷ Remove the IDE cable and power
cable from the cable binder.
NOTE:
Beware of all surrounding sharp edges when
connecting and arranging cables.
IDE cable
connector
÷ Align the connectors correctly and
connect securely.
IDE cable
①
③
Drive 2
Power cable
connector
Binder strap
DC INPUT
1
5V G G 12V
2
Power cable