Pioneer PRA-DW11 Mode D'emploi page 13

8 Press the STANDBY/ON button to
turn on power again to the PRV-LX1.
NOTE:
When the unit's power is turned on again,
if the monitor screen again shows the
setting menu (see step 4 "monitor screen
message"), there is a possibility that the
commercial software disc inserted in step
6 was not marketed for region 2. In this
case, exchange the disc for a proper region
2 disc, and perform the setting again
beginning from step 4.
9 Press the DRIVE SELECT button
several times until the DVD2 indicator
lights.
0 If setting steps 4 – 8 have been
performed:
Press the PLAY button and confirm
that play is possible from drive 2
(DVD2).
If setting steps 4 – 8 have NOT
been performed:
Press the drive 2 EJECT button to
open the disc table, and install the tray
p a n e l i n a c c o r d a n c e w i t h t h e
instructions "# Install tray panel 2 to
the drive 2 disc table" found on the
p r e v i o u s p a g e . T h e n , l o a d a
commercial software title in the disc
DVD 2 indicator
STANDBY/ON button
table and press the PLAY button to
confirm that playback is possible from
drive 2 (DVD2).
- Press the STOP button to stop
playback, and press the drive 2 EJECT
button to open the disc table.
= Remove the disc and press the drive
2 EJECT button to close the disc table
again.
12. Completion of installation
1 Press the main unit's front panel
STANDBY/ON button and wait until
the unit enters the standby mode.
2 Once the main unit is in the standby
mode, set the unit's main power
switch (on rear panel) to OFF, then
disconnect the power cord from its
power outlet.
NOTE:
Do not leave the power to the unit turned
on when tray panel 2 is not installed (see
step 11 for installation instructions). If tray
panel 2 is not installed, dust may be pulled
into the unit more easily, leading to
malfunctions in recording and playback.
DRIVE SELECT button
ENTER button
Installation
Drive 2 EJECT button
PLAY button
STOP button
13
PRA-DW11
En