Burley Dash MIK HD Manuel D'instructions page 4

FAILURE TO COMPLY WITH THE INSTRUCTIONS AND WARNINGS IN THIS MANUAL
COULD RESULT IN SERIOUS INJURY OR DEATH OF THE PASSENGER OR RIDER.
• WARNING: Do not attach additional luggage to the
child carrier.
– It is recommended to carry any additional luggage or
accessories at the opposite end of the bicycle from the
Bicycle Seat (i.e. use a front luggage carrier when using
a rear Bicycle Seat).
• WARNING: The cycle may behave differently with
a child in the seat.
– The load of a Child Bicycle Seat may lessen the stability
and alter the riding characteristics of the bicycle,
particularly regarding steering and braking.
– Presence of a Child Bicycle Seat on a bicycle may
require alteration of the method used by the rider to
mount or dismount the bicycle. Care must be taken
whenever the rider gets on or off the bicycle.
• Before each ride, ensure the mounted Bicycle
Seat does not interfere with braking, pedaling, or
steering of the bicycle.
• WARNING: Never leave the bicycle parked with a
child in the Bicycle Seat unattended.
– Never leave the child in a Bicycle Seat with the bicycle
supported only by a kickstand.
• WARNING: Do not modify the Bicycle Seat.
• WARNING: Do not use the Bicycle Seat if any part
is broken.
• WARNING: If any crack forms, or if the surface
starts to deconstruct, this indicates that the life
of the seat has been reached and it should be
replaced. A professional shall be contacted in case
of doubt.
• WARNING: Always check the surface temperature
of the seat before any use.
• WARNING: Always ensure that the head of your
child is supported in reclined position.
• WARNING: This child seat is not suitable for use
4
INTRODUCTION
WARNING
during sporting activities.
• WARNING: The Safety Strap must always be
fastened to the bicycle frame before use (refer to
the "Securing the Safety Strap" section).
• The bicycle to which the Bicycle Seat is attached
must be in good working order, of a type appro-
priate for the additional load, and of proper size
and adjustment for the rider.
• Check the bicycle user manual, or contact the
bicycle manufacturer/supplier to obtain applicable
information, to ensure the bicycle is appropriate
for use with a Child Bicycle Seat.
• Ensure seat is properly mounted per manual
instructions.
• Ensure that any exposed rear saddle springs are
covered with a suitable spring guard.
• Ensure that there are no sharp objects within
reach of the child, e.g. frayed cables.
• The red reflector that came attached to the
Bicycle Seat, which complies with CPSC regula-
tions, must be visible on the rear of the Bicycle
Seat whether the Bicycle Seat is on the bicycle
or not.
• Ensure that you do not exceed the load capacity
of the bicycle rack that is used to attach the
Bicycle Seat to bicycle.
– This Bicycle Seat should only be attached to MIK HD
• Always remove the Bicycle Seat from the bicycle
when the bicycle is being transported on/outside
a motor vehicle. This is necessary because the
force of the high wind and air turbulence on the
ENG FRA
racks which are compliant with ISO 11243 (see page 6
for compatibility information).
ESP
BURLEY.COM