Kärcher IVR-L 40/12-1 Mode D'emploi page 15

Illustration C
Device with a motor (IVR-L...-1)
Illustration D
Device with two motors (IVR-L...-2)
ATTENTION
Operation with a motor
Risk of damage to the drive motor
Switch between the level settings quickly.
The switch has multiple level settings:
0 The device is off.
1 Motor 1 is switched on.
2 Motors 1 and 2 are switched on.
3. Switch on the device at the trigger.
Illustration D
ATTENTION
Operation with a motor
Risk of damage to the drive motor
Switch between the level settings quickly.
The switch has multiple level settings:
0 The device is off.
1 Motor 1 is switched on.
2 Motors 1 and 2 are switched on.
4. Start vacuuming.
Suction process
Note
Only immerse the accessory halfway when
vacuuming liquids to encourage sufficient
air.
Checking the filling level display
See graphics pages for illustration
Illustration E
Note
The red marking on the drain hose shows
the maximum permissible filling level.
ATTENTION
Risk of damage to the device
The liquid container will overflow within a
few seconds of filling.
Constantly check the filling level in the liq-
uid container when filling large quantities of
liquid.
Emptying the liquid container
For the figures, please refer to the graphics
pages
1. Switch the device off and disconnect it
from the power supply.
2. Move the device to the waste water tank.
3. Empty the liquid container:
a Connect the drain hose to the upper
hose coupling.
Illustration F
b Hold the drain hose over a suitable
collecting container and drain the con-
tents.
4. Dispose of or reuse the contents in ac-
cordance with statutory regulations.
Emptying the liquid container by
See graphics page for illustrations
1. Switch the device off and disconnect it
from the power supply.
2. Move the device to the waste water tank.
3. Remove the suction head, (see chapter
Removing the suction head).
4. Remove all accessory parts.
5. Prepare the liquid container for empty-
ing:
 By means of tilting the device Tc
(device with tilting device Tc)
a Open the lock of the liquid container.
Illustration G
 Using the crane grommet (device
without tilting device Tc)
a Lift the device by the crane grommets
(see chapter Device description) us-
ing suitable lifting gear.
DANGER
Failure to observe the weight
Risk of injury from falling device
Observe the applicable accident prevention
guidelines and safety instructions.
Every time before lifting, check to ensure
correct functioning of the lifting device.
Only lift the device via the provided crane
grommet.
Ensure that there will be no unintentional
unhooking of the lifted load.
The crane may exclusively be operated by
qualified staff.
English
tilting
15