Publicité
Les langues disponibles
Les langues disponibles
Turn choke control knob anticlockwise (close).
Push primer pump until fuel is visible in primer pump.
Securely hold the chain saw.
When starting the chain saw place the unit on a flat ground and hold the front handle with
left hand and hold firmly the rear end of rear handle with right knee and pull starter handle
with right hand.
Make sure guide bar and saw chain are not touching anything when starting the saw.
Pull starter handle several times until first firing sound is heard.
5. Choke control knob (Open)
Turn choke control knob clockwise (open).
Pull starter handle until engine starts.
Pull throttle lever and the throttle latch will be released.
Starting the warm engine
1. Chain brake ACTIVATED position
Confirm there is fuel and chain oil in the tanks.
Press hand guard forward.
(Chain brake ACTIVATED position)
Place ignition switch in run position.
Securely hold the chain saw.
Pull starter handle.
Choke may be used if necessary, but after first firing sound pull throttle trigger a little to
release throttle latch and choke.
After choke control knob is turned and then knob is returned to original position, throttle
remains a little open (latch condition).
Running
1. Chain brake RELEASED position
2. Throttle trigger lockout
3. Throttle trigger
After engine starts, allow it to idle for a few minutes.
Pull front hand guard towards the operator immediately.
(Chain brake RELEASED position)
Squeeze throttle trigger gradually to increase engine revolution.
The chain starts moving when the engine reaches 4400 r/min approximately.
Ensure proper acceleration and lubrication of saw chain and guide bar.
Do not run the engine at high speed unnecessarily.
Be sure that saw chain stops moving when throttle trigger is released.
19
Publicité
