Bosch SmartphoneGrip BSP3200 Notice D'utilisation D'origine page 9

Safety Instructions
Read all the safety information and in-
structions. Failure to observe the safety in-
formation and follow instructions may result
in electric shock, fire and/or serious injury.
Save all safety warnings and instructions for future ref-
erence.
The term eBike battery is used in these instructions to
mean all original Bosch eBike rechargeable battery packs
from the system generation the smart system.
The terms drive and drive unit used in these operating in-
structions refer to the original Bosch drive units from the
system generation the smart system.
Read and observe the safety warnings and instruc-
u
tions contained in all the operating instructions for
the eBike components and in the operating instruc-
tions of your eBike.
Do not allow your attention to be diverted from sur-
u
rounding traffic when using Bosch eBike components
and always ride with both hands on the handlebars. Al-
ways observe the applicable legal provisions in your
country for the permitted use of your eBike in road
traffic. In particular, note that it is prohibited to pick
up or hold your smartphone in your hand in road
traffic.
Set the smartphone brightness so that you can ad-
u
equately see important information such as speed and
warning symbols. Incorrectly set brightness may lead to
dangerous situations.
The contact surfaces of the display holder may be-
u
come very hot (> 60 °C). Allow the contact surfaces to
adjust to the ambient temperature before you touch
them. This is particularly important when using a Smart-
phoneGrip.
Consult a doctor before using fitness app programs.
u
Fitness apps may cause people to overexert themselves
physically.
Always observe local restrictions for using electronic
u
devices.
Avoid operation near your body for extended periods.
u
Do not stand your eBike upside down on its saddle and
u
handlebars if the SmartphoneGrip or its holder pro-
trude from the handlebars. This may irreparably dam-
age the SmartphoneGrip or the holder.
Do not use the SmartphoneGrip as a handle. Lifting the
u
eBike up by the SmartphoneGrip can cause irreparable
damage to the SmartphoneGrip.
Do not open the SmartphoneGrip. Opening the Smart-
u
phoneGrip may damage it beyond repair and void any
warranty claims.
Caution! When using the SmartphoneGrip with
u
Bluetooth® and/or Wi-Fi, interference can occur with
other devices and equipment, aircraft and medical
devices (e.g. pacemakers, hearing aids). Likewise, injury
to people and animals in the immediate vicinity cannot be
Bosch eBike Systems
excluded entirely. Do not use the SmartphoneGrip with
Bluetooth® in the vicinity of medical devices, petrol sta-
tions, chemical plants, areas with a potentially explosive
atmosphere or on blast sites. Do not use the Smart-
phoneGrip with Bluetooth® in aeroplanes. Avoid opera-
tion near your body for extended periods.
The Bluetooth® word mark and logos are registered trade-
u
marks owned by Bluetooth SIG, Inc. Any use of such
marks by Robert Bosch GmbH, Bosch eBike Systems is
under license.
Product Description and
Specifications
Intended Use
The Bosch SmartphoneGrip is designed to hold and charge a
smartphone on the handlebars of a Bosch eBike of the sys-
tem generation the smart system.
In addition to the functions shown here, changes to software
relating to troubleshooting and functional modifications may
be introduced at any time.
The SmartphoneGrip is suitable for cycling on reinforced
paths without jumps and with few ledges (< 15 cm) at aver-
age speeds of between 15 and 25 km/h, for example on as-
phalt roads, country paths, paths reinforced with gravel or
sand, and reinforced woodland paths.
In case of improper use, there is a risk of the smartphone
coming loose from the SmartphoneGrip, falling down and
becoming damaged as a result. There is also a considerable
risk of an accident if the smartphone falls out.
Product Features
The numbering of the components shown refers to the illus-
trations on the graphics pages at the beginning of the
manual.
All illustrations of bike parts except for the drive unit, Smart-
phoneGrip (including operating unit), speed sensor and the
corresponding holders are a schematic representation and
may differ on your eBike.
(1) Front retraining bracket, movable
(2) Rear retaining bracket, fixed
(3) USB port with USB cap
(4) Release mechanism
(5) SmartphoneGrip mount
(6) Snap-in hook
(7) Socket contacts
(8) SmartphoneGrip contacts
(9) Status LED
(10) Inductive charging coil
(11) Keypad lock
a)
(12) Hex key
a)
(13) Smartphone
a) Not included in the scope of delivery
English – 1
0 275 008 3SG | (09.02.2024)