Dreame DreameBot L10 Ultra Manuel D'utilisation page 21

Routine Maintenance
Filter
1. Remove the filter and tap its basket gently.
Note: Do not attempt to clean the filter with a brush, a finger or sharp objects to
prevent damage.
2. Rinse the dust bin and filter with water and dry them completely before
reinstalling.
Note:
·
Rinse the dust bin and filter with clean water only. Do not use any detergent.
·
Use the dust bin and filter only when they are completely dry.
Robot Sensors and Charging Contacts
Wipe sensors and charging contacts of the robot by using a soft, dry cloth:
·
The cliff sensors and the carpet sensor on the bottom of the robot
·
Charging contacts at the back of the robot
·
The edge sensor on the side of the robot
·
LDS on the top of the robot
·
The bumper on the front of the robot
24h
Note: Wet cloth can damage sensitive elements within the robot and the base
station. Please use dry cloth for cleaning.
Laser Distance Sensor (LDS)
Edge Sensor
Bumper
Charging Contacts
Cliff Sensors
Carpet Sensor
EN
19