Morso Spin Mode D'emploi page 24

TECHNICAL DATA
Rated voltage
Maximun electic input
Classification
Cord length
Motor Knob Introduction
Gear
OFF: Motor OFF
SLOW: Slow RPM / 1.5 rotations per minute
FAST: Fast RPM / 3 rotations per minute
About the Spin Feature
1. Connect the connector to the electrical outlet.
2. Push in the control knob and turn it slowly conter-
clockwise undtil the "SLOW" position or "FAST" posi-
tion, and see if the pizza stone can rotate properly.
3. After the pizza stone starts to rotate, pizza can be put
in the Morsø Forno Spin after 15 to 25 mins of preheat.
4. If the pizza stone is not rotating, turn the motor knob
to the "OFF" position, and remove the pizza stone from
the tray to check if there is any obstruction of the pizza
stone. Please remove the obstruction then turn the mo-
tor knob to "SLOW" or " FAST" position.
24
220-240, 50 Hz
1.2 W
IPx4
2 m
MOTOR INSTRUCTIONS
1. Please use the Morsø Forno Spin at a tem-
perature of -10 °C + 40 °C.
2. If the pizza stone rotation function is found
to be abnormal when the Morsø Forno Spin
is used at a temperature of -10 °C - 5 °C;
Please ignite the burner to preheat for 15
minutes, and then restart the pizza stone
rotation with the motor knob.
3. If the Morsø Forno Spin is used at a tem-
perature lower than -10 °C, the motor may
not work normally due to the low temper-
ature, thus the pizza stone rotation func-
tion cannot be used.
4. If the Morsø Forno Spin is used at a tem-
perature is higher than 40 °C, the motor
may overheat or fail to start due to the
high temperature, and the pizza stone ro-
tation function cannot be used.