Morso Spin Mode D'emploi page 16

GENERAL INFORMATION
IMPORTANT
Read these instruction carefully prior to
use. Familiarise yourself with the Morsø
Forno Spin before connecting it to the
power outlet and gas bottle. Keep these
instructions for future reference.
IMPORTANT
Do not use the Morsø Forno Spin unless all
the parts are in place and the Morsø Forno
Spin was assembled according to the as-
sembly instructions.
IMPORTANT
Do not operate the Morsø Forno Spin if
there is any sign of damage to the Morsø
Forno Spin itself, the power cord or the
gas hose & regulator.
FOR YOUR SAFETY
Failure to comply with these instructions could result
in a fire or explosion which could cause serious bodily
injury, death or property damage. CAUTION: Accessible
parts may be very hot. Keep young children away. DO
NOT modify this appliance.
Parts sealed by the manufacturer or their agent must
not be manipulated by the user.
• If this information is not followed exactly a fire causing
death or serious injury may occur.
• DO NOT USE ADAPTERS.
• Only use in well ventilated areas.
Protect Children
• Keep children away from the Morsø Forno Spin during use and
until the Morsø Forno Spin has cooled after you have finished.
Do not allow children to operate the Morsø Forno Spin.
• Always ensure that no sporting or physical activities
are carried out in close proximity to the Morsø Forno
Spin during use and while still hot.
Installation and Assembly
• Wear proper safety clothing when assembling the the
Morsø Forno Spin. This includes but is not limited to,
grill gloves, apron, safety glasses, long sleeves.
• Follow the assembly instructions as stated in this manual.
• Take care to avoid unnecessary twisting of the power cable
and gas hose.
• Keep electrical connections dry.
16
• Make sure the power cable and gas hose is not tangled
up or damaged. Do not use the Morsø Forno Spin if
the power cable and/or gas hose shows any sign of
damage.
• Make sure to place the Morsø Forno Spin on a level
plane, with a sufficiently strong surface to insure maxi-
mum stability
Electrical and gas safety
• The fuse must be a residual current circuit breaker with
a measured residual current of no more than 30 mA
• The device may only be connected to a socket that is
correctly installed.
• Do not touch the mains plug with wet hands! Always
pull out the mains plug at the plug and not by the cable.
• Handle the power cable and gas hose with care. Do
not bend, crush, pull or drive over the power cable
and/or the gas hose, protect from sharp edges, oil and
heat.
• Do not lift the device using the power cable or gas
hose, do not use for any other purposes than intend-
ed.
• Check the plug, power cable and hose before each use.
• If the power cable and/or gas hose is damaged imme-
diately disconnect it. Never use the device if the power
cable and/or gas hose is damaged.
• Make sure the device is unplugged when not in use.
• Make sure that the device is switched off before plug-
ging it in the circuit.
Extension cords
• If it is necessary to use an extension cord, make sure
to use an appropriate cord that is suitable for out-door
use.
• Examine the extension cord for damage before use.
• When using long extension cords, make sure to fully
unwind the extension cord before using it.
• Do not leave an extension cord wound up in its hous-
ing when using the Morsø Forno Spin
• Make sure to follow local laws and regulations before
using the Morsø Forno Spin.
IMPORTANT
Accessible parts may be very hot. Keep
young children and pets away.