Morso Spin Mode D'emploi page 19

GENERAL INFORMATION
IMPORTANT
Read these instruction carefully prior to use.
Familiarise yourself with the appliance before
connecting it to it's gas container or power
supply. Keep these instructions for future
reference.
IMPORTANT
The Morsø Forno Spin must only be used
with the hose and regulator that is supplied
with the product! Do not mount any other
regulators or hoses to this product, as
this can a cause very serious hazard.
IF YOU SMELL GAS
1. Shut off gas to the Morsø Forno Spin
at its source, if possible.
2. Extinguish any open flame.
3. If odour continues immediately, call
your gas supplier or fire department.
Replacement of pressure control and
hose connector shall be carried out us-
ing Morsø genuine products only. Contact
your local dealer.
Gas Installation Codes
• Appliance must be used in accordance with the instal-
lation requirements of your gas supply authority.
• Appliance for use with bottled gas are labelled 'pro-
panegas'.
Clearances
Minimum Clearances from combustible materials must
be: Rear - 300 mm Sides - 300 mm Above - 2000 mm
Specifications
Morsø Forno Spin specifications can be found on the
data label attached to the rear of the Forno Spin body.
Hose & Regulator Safety
The regulator and hose assembly supplied with the ap-
pliance are suitable for Propane & Butane mix Gas only.
The pressure regulator and hose assembly supplied with
the Morsø Forno Spin must be used. Replacement of
pressure control and hose connector shall be carried
out using Morsø genuine products only. Contact your
local dealer.
When connecting the hose and regulator assembly to
the gas cylinder, take care to avoid unnecessary twist-
ing of the flexible hose.
Twist
After the assembly has been secured, turn on the gas
and check for leaks by brushing a soap and water solu-
tion over all connections.
If you are unable to correct the leak by tightening the
connections, turn off the gas and contact the supplier
immediately.
Always ensure the Morsø Forno Spin is kept away from
flammable materials and the gas cylinder clear of any heat
source.
When changing over from an empty gas cylinder to a
full one, make sure this procedure is carried out in a well
ventilated location, outside, away from people and away
from any sources of ignition; such as nakedflames, pilot-
flames, electric heaters/equipment.
Gas Cylinder Use & Safety
This is a 30mb pressure appliance and must only be
used with the supplied regulator. Your Morsø Forno Spin
is designed for use with Propane & Butane mix gas cylin-
ders certified to the CE and UKCA standards.
The gas cylinder should be filled by a reputable gas sup-
plier and visually inspected and re-qualified at each filling.
Always keep cylinder in an upright position. Always
close the cylinder valve when the Morsø Forno Spin is not
in use. Do not subject gas cylinder to excessive heat.
NEVER STORE YOUR GAS CYLINDER INDOORS
If you store your Morsø Forno Spin indoors, ALWAYS dis-
connect the gas cylinder first and store the cylinder safely
outside.
Cylinders must be stored outdoors in a well ventilated
area out of reach of children, and must not be stored in
a building, garage or any other enclosed area.
Fold Perish
19