Télécharger Imprimer la page

Morso Spin Mode D'emploi page 23

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 75
GENERAL INFORMATION
CONNECTING & DISCONNECTING
TO GAS SOURCE
Familiarise yourself with the general information and
safety guidelines located at the front of this manual.
Check
1. Gas cylinder is filled. A sloshing sound will be heard
when shaken.
2. The burner control is in the 'OFF' position
Connecting
1. Ensure the valve is in the OFF position
2. Check for any damage to the cylinder connection.
3. Attach the regulator to the cylinder valve.
4. Use a soapy water solution to check the joint. If bub-
bles appear the connection will need to be retight-
ened.
Length
Width
550 mm
528 mm
IMPORTANT
• IMPORTANT: Before connecting and
disconnecting Morsø Forno Spin to gas
source, make sure burner controls are in
'OFF' position.
• CAUTION: When the Morsø Forno Spin is
not in use, the gas cylinder must be discon-
nected.
• Check that the seals between the Morsø
Forno Spin and the gas cylinder are in
place and in good condition before con-
necting the gas cylinder.
• Do not use the Morsø Forno Spin if it has
damaged or worn seals.
• Check performance of burner prior to use.
• Do not smoke when attempting to ignite
Morsø Forno Spin.
• Never use volcanic rock, heat beads or oth-
er material.
• Always use protective gloves when han-
dling hot components.
• do not look into the Morsø Forno Spin when
lighting it.
• Do not stand too close to the Morsø Forno
Spin when it is in operation. As it will be very
hot and give of a lot or directional heat out of
the opening of the Morsø Forno Spin.
Gas Knob Introduction
Gear
OFF: Fire OFF
MAX: Maximum Fire
MIN: Minimum Fire
LIGHTING INSTRUCTIONS
1. Push in the control knob and rotate it slowly conter-
clockwise until the Max position.
2. If the Morsø Forno Spin ignite successfylly please
keep pressing the control knob for ten seconds to
keep the fire running.
3. If the Morsø Forno Spin does not ignite, return the
control knob back to "OFF" position and try again.
4. If the Morsø Forno Spin does not ignite after five
attempt, leave the controll knob in the OFF position,
Check all connections and wait 5 minutes before
trying again.
Height
352 mm
IMPORTANT
Do not smoke at any time when attempting
to ignite the Morsø Forno Spin.
Do not leave the Morsø Forno Spin unat-
tended when alight.
Do not look Directly into the Morsø Forno
Spin when lighting it. Keep a safe distance.
23

Publicité

loading

Produits Connexes pour Morso Spin