Home Decorators Collection CARLEY CF2003-W Guide D'utilisation Et D'entretien page 9

Assembly - Hanging the Fan (continued)
5
Making the electrical connections
WARNING: To avoid possible electrical shock, ensure the
electricity is turned off at the circuit breaker or main fuse box
before wiring.
WARNING: Check to see that all connections are tight,
including the ground, and that no bare wire is visible at the
wire nuts, except for the ground wire.
□
Insert the receiver (L) into the mounting bracket (A) with
the at side of the receiver (L) facing the ceiling.
Follow the steps below to connect the fan to your house
supply wires. Secure the wire nuts (AA) supplied with the
electrical hardware by wrapping the connections with
electrical tape.
□
Plug one lead wire of light (with 3P small male connector)
and one lead wire of fan (with 3P big male connector) to
the corresponding female connector on the receiver (L).
□
Connect the black (120V line voltage) wire from the outlet
box to the black wire from the receiver (L).
□
Connect the white (120V neutral voltage) wire from the
outlet box to the white wire from the receiver (L).
□
Connect the green (120V ground) wire from the outlet box
to the green wires from the hanger ball (D), mounting
bracket (A) and receiver (L).
□
Secure the wire connection with the wire nut (AA) provided
with the electrical hardware.
□
After connecting the wires, spread them apart so that the
green and white wires are on one side of the outlet box.
This side up
120V Line
voltage-Black
120V Neutral
voltage-White
Fan Line
voltage-Black
Fan Neutral
voltage-White
L
9
Please contact 1-877-592-5233 for further assistance.
Figur e 5
Outlet Box
120V Ground-Green
AA
Receiver
Ground-Green
Hanger ball
Ground-Green
Mounting bracket
Ground-Green
Female Connector
Male Connector
A
D
G
Figure 6
HOMEDEPOT.CA/Hubspace