Home Decorators Collection CARLEY CF2003-W Guide D'utilisation Et D'entretien page 7

Assembly - Hanging the Fan
1
Install the mounting bracket to the
outlet box
To reduce the risk of fire, electric shock, or other
WARNING:
personal injury, mount the fan only to an outlet box or supporting
system marked acceptable for fan support and use the mounting
screws provided with the outlet box.
□
Align 2pcs screws (BB/CC, not included) through washers
(EE/FF, not included) and then install screws (BB/CC,
not included) through mounting bracket (A) onto the outlet box.
□
If outlet box has thread holes, please use the screws - M4x25
(BB, not included), washer - D4(FF, not included) and washer -
D15(DD, not included).
If outlet box doesn't have thread holes, please use the screws
-ST4.8x77 (CC, not included), washer - D5(EE, not included)
and washer - D15(DD, not included).
Figure 1
Outlet Box
DD
FF/EE
BB/CC
2
Attaching the downrod to the fan
motor assembly
□
Loosen the two
(QQ) from the fan motor assembly (G) coupling.
□
Remove the hitch pin (PP) and lock pin (OO) from the
downrod (E). Remove the hanger ball (D) from the
downrod (E) by loosening the hanger ball set screw
(NN), and removing the cross pin (MM), then sliding
the hanger ball (D) off of the downrod (E).
□
Carefully feed the fan wires from the fan motor assembly (G)
up through the downrod(E). Thread the downrod (E) into the
fan motor assembly (G) coupling. Align the holes and reattach
the lock pin (OO) and the hitch pin (PP).Tighten the set
screws (QQ).
A
7
fan motor assembly coupling set screws
Figure 2
HOMEDEPOT.CA/Hubspace
Please contact 1-877-592-5233 for further assistance.