Home Decorators Collection CARLEY CF2003-W Guide D'utilisation Et D'entretien page 11

Assembly - Hanging the Fan (continued)
8
Install the light housing
□
Remove one screw from the connecting plate (P) of fan-motor
assembly (G). And loosen the remaining 2 screws, leaving about
3/4 space.
□
Locate the key holes of light housing (H).
□
Place two key holes of light housing (H) to the mounting screw
that was loosened on the connect plate (P).
□
Reattach 1pc screw through light housing (H) in place to the
connecting plate (P).
□
Tighten 3pcs screws until light housing (H) is secure.
CAUTION: To reduce the risk of electric shock, disconnect the
electrical circuit to the fan before installing light kit.
Figure 11
9
Install the LED module
□
Remove 3pcs pre-installed screws from the inside of the light
housing pan (H). Figure 12.
□
Connect the male connector from the LED module (I) to the female
connector from the fan-motor assembly (G). Figure 13.
□
Locate 3pcs screw holes of LED module (I) in line with the screw
holes of light housing (H).
□
Reattach 3pcs screws through the screw holes of LED module (I).
Figure 14.
□
Tighten the screws until LED module (I) is secure.
Figure 12
Figure 13
Figure 14
11
Please contact 1-877-592-5233 for further assistance.
screws
HOMEDEPOT.CA/Hubspace