Trix V 200 Serie Mode D'emploi page 7

Safety Notes
• This locomotive is to be used only with an operating
system designed for it.
• Use only switched mode power supply units and transfor-
mers that are designed for your local power system.
• This locomotive must never be supplied with power from
more than one power pack.
• Pay close attention to the safety notes in the instructions
for your operating system.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• The feeder track must be equipped to prevent interference
with radio and television reception, when the locomotive
is to be run in conventional operation. The 611 655 inter-
ference suppression set is to be used for this purpose.
The interference suppression set is not suitable for digital
operation.
• WARNING! Sharp edges and points required for operation.
All manuals and user guides at all-guides.com
Functions
• This model is designed for operation with H0 2-rail
• Analog 14 volts DC, digital 22 volts AC.
• This locomotive comes equipped with an eight-pin
• Trix motor vehicles must not be operated on digital
General Notes
• The operating instructions and the packaging are a compo-
• When installing a digital decoder, the light bulbs already
• Please see your authorized Trix dealer for repairs or spare
• http://www.maerklin.com/en/imprint.html
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Trix have been installed in
Trix products or where Trix products have been converted in such a way
that the non-Trix parts or the conversion were causal to the defects and /
or damage arising. The burden of presenting evidence and the burden of
proof thereof, that the installation of non-Trix parts or the conversion in or
of Trix products was not causal to the defects and / or damage arising, is
borne by the person and/or company responsible for the installation and /
or conversion, or by the customer.
DC systems (track according to NEM standards) with
conventional DC power packs.
NEM 652 connector for digital operation and can be retro-
fitted with decoders having this kind of connector.
systems without an built-in engine decoder (Motor can be
damaged!).
nent part of the product and must therefore be kept as well
as transferred along with the product to others.
installed in the locomotive must be replaced by the
610 080 light bulbs.
parts.
7