Mistral HG11062 Instructions De Montage, D'utilisation Et Consignes De Sécurité page 29

Store the product in a safe location, out of the
reach of children.
Do not place heavy or sharp objects on the
board .
1
Do not drag the product over hard and abra-
sive surfaces before storing it.
Ensure there is no sand or gravel in the folds
of the board . This could cause abrasion or
1
holes during storage.
Check the product for wear or ageing after it
has been stored for an extended period.
Storing the board rolled up in cold weather
1
for extended periods can cause tears in the
material.
When not in use for an extended period, we rec-
ommend to store the accessories and board
in the backpack provided (e.g.: US fin, paddle,
10
drybag, air pump, repair kit, seat, leash).
Cleaning and care
Do not use aggressive cleaning agents, brushes
with metal or nylon bristles or sharp or metallic
objects such as knives.
Only use mild cleaning agents.
Clean the board after every use, with the
1
valve needle closed.
1b
Remove the US fin per chapter "Removing
12
the US fin".
Place the board on a clean, dry and even
1
surface.
Rinse the board and US fin
1
water and mild soap to remove salt crystals,
grains of sand and other particles.
Wipe all parts of the product down with a dry,
soft cloth. Then allow the board
to dry thoroughly.
12
Repair and maintenance
Carry out any repairs in
a well ventilated location and avoid inhaling
toxic fumes. Avoid contact with the skin or the
eyes. Keep all repair supplies (glue, solvent,
etc.) out of the reach of children.
seams can only be repaired by the manufacturer
of the board
Never repair large holes yourself. You can
repair small holes with the included repair kit.
Check the board
tears before every use. If air escapes from the
board
defective valve
board
Repairing the valve
Proceed as follows to check valves
Turn the valve cap
1
it from the valve
Ensure there is no sand or other foreign objects
in the valve
Close the valve needle
Turn the valve cap
remove it from the valve
Place the valve wrench
until it covers the entire valve
Tighten the valve cap
Close the valve
Fully inflate the board
Close the valve
Pour soapy water over the area around the
valve
is tight. If bubbles form around the valve
air is escaping. The valve
with fresh be tightened or replaced.
12
Tightening the valve
and US fin to tighten the valve
1
ised. Injuries may otherwise occur.
Place the valve wrench
until it covers the entire valve
valve
Repeat the bubble test.
If bubbles form around the valve
ening, it needs to be replaced.
Replacing the
Place the valve wrench
until it covers the entire valve.
Never glue the seams. The
.
1
for pressure loss, holes or
1
, it may be due to a leaking valve
1
or a hole in the actual
1a
.
1
anti-clockwise and remove
1e
.
1a
.
1a
.
1b
anti-clockwise and
1e
.
1a
over the valve
11
, turning clockwise.
1e
with the valve cap
1a
.
1
.
1a
. If bubbles do not form, the valve
1a
1a
(Fig. D):
1a
Never use the valve wrench
if the board
1a
over the valve
11
, turning clockwise.
1a
valve (Fig. D):
1a
over the valve
11
,
1a
for leaks:
1a
1a
.
1a
.
1e
1a
,
1a
either needs to
11
is pressur-
1
1a
. Tighten the
1a
after tight-
1a
1a
GB/IE 29