Mistral HG11062 Instructions De Montage, D'utilisation Et Consignes De Sécurité page 26

Installing the US fin (Fig. E)
Insert the metal plate
middle of the slot and slide forward.
Note: You can use the screw
plate along the slot.
Insert the back of the US fin
and slide back. Insert the front of the US fin
in the fin box and slide the US fin
until the hole in the fin is located over the hole
in the metal plate
12a
Insert the screw
12b
screw it in along with the metal plate
secure the US fin
12
Note: Always ensure the fins are facing towards
you when carrying the board
careful not to injure others with the board
windy conditions.
Assembling the single-blade
paddle (Fig. K)
Loosen the locking lever
pole .
4
Insert the paddle handle
pole .
4
Extend the paddle handle
length.
Note: For information about the recommended
paddle length, please see chapter "Adjusting
the paddle length".
Press in the locking lever
pole to lock the paddle handle
4
Insert the paddle blade
the extension pole
inserted all the way in the pinhole on the pad-
dle blade . You must hear the pin on the ex-
2a
tension pole click into place when it locks
4
into the pinhole of the paddle blade
Assembling the double-bladed
paddle (Fig. K)
Loosen the locking lever
pole .
4
26 GB/IE
in the hole in the
12a
to slide the
12b
in the fin box
12
forward
12
.
in the hole in the fin and
to
12a
.
. Be particularly
1
1
on the extension
4a
in the extension
3
to the desired
3
on the extension
4a
.
3
in the opening on
2a
. Ensure the locking pin is
4
.
2a
on the extension
4a
Insert the second paddle blade
of the extension pole
. Turn the second paddle blade
4a
desired angle.
Push in the locking lever
pole to lock the second paddle blade
4
place.
Insert the paddle blade
12
the extension pole
in inserted all the way in the pinhole. You must
hear the pin on the extension pole
place when it locks into the pinhole.
Disassembling the product
in Select a clean, even surface with adequate
space to disassemble the product.
Disassembly requires the following steps:
· Removing the US fin
(foot rest
17
· Releasing air from the board
· Rolling up the board
· Disassembling the paddle into the individual
parts
Note: Remove the US fin
air from the board
Removing the US fin:
Remove the US fin
the US fin" in reverse order.
Disassembling the paddle:
Disassemble the paddle per chapter "Assem-
bling the single-blade paddle" or "Assembling
the double-bladed paddle" in reverse order.
Releasing air (Fig. C1-4):
Place the dry board
open the two valve caps
valve needle
Only push the valve needle
can escape slowly.
Release the air.
You can alternatively use the air pump
fold the board
ing the hose
(Deflate). Connect the hose
in the end
2b
with the locking lever
4
2b
on the extension
4a
in the opening on
2a
. Ensure the locking pin
4
4
and other accessories
12
, seat )
15
1
1
before releasing
12
.
1
per chapter "Installing
12
flat on the ground and
1
by pushing in the
1e
whilst turning clockwise.
1b
in slightly so air
1b
as flat as possible by attach-
1
backwards on the air pump
14
to one of the
14
to the
in
2b
click into
to
13
13