Mistral HG11062 Instructions De Montage, D'utilisation Et Consignes De Sécurité page 27

valves . The valve head must be down. Turn
1a
the valve head to the right (Fig. C4), pump and
extract the remaining air from the board
until it is completely flat.
Then turn the valve head anti-clockwise so it
comes out upward (Fig. C1).
Now place the board
(Fig. N1).
Then fold the board
1
nose over the tail (Fig. N2).
Then fold the tail and nose again, making sure
the external fins under the board
buckle (Fig. N3).
Do not fold the board
outside edges of the fin box. This will
cause excessive tension in the board
Now fold the opposite side to about the middle
(Fig. N4).
Then fold the board
1
opposite side so the external fins are on top
(Fig. N5).
Use the strap to lash up the board
Using the product
Adjusting the paddle length
Stand straight and raise one arm up; bend
your palm to about a right angle (Fig. J).
Open the locking lever
slide the extension up until the paddle handle
fits below your bent palm.
Note: For optimal handling, the second pad-
dle blade /paddle handle
2b
firmly attached to the extension pole
the locking lever . If necessary, you have to
4a
adjust the screws of the locking lever
sure that the second paddle blade
handle is firmly seated.
3
Close the lock on the locking lever
paddle is now set to the correct length.
Important: Do not extend the paddle
handle past the "STOP" mark. The
3
paddle will otherwise become unsta-
ble and could break.
1
flat on the ground
1
once and place the
do not
1
along the
1
.
1
once more onto the
.
1
on your paddle and
4a
must be
3
using
4
to en-
4a
/paddle
2b
. Your
4a
Using on the water
Note: Be careful not to hurt others when carrying
the board in windy conditions. Always keep the
1
fins towards you.
Note: You can use the board
sitting.
Standing up:
In this position, use the leash
safety measure.
Always attach the leash
offshore winds.
If you find yourself in distress, always stay on
the board . Never abandon the board
1
in strong offshore winds, or you may drown. In
this case, use the international distress signal to
draw attention to yourself: stand or sit on the
board and slowly and clearly raise and
1
lower your straight arms at your side (Fig. P).
Attach the leash
9
1. Attach the leash
2. Pull the loop on the leash
D-ring .
1c
3. Pull the leash strap
the leash .
9b
4. When standing to use the board
deeper waters, attach the leash
leg/ankle (Fig. H/I).
Seated:
To use the board in a seated position, you will
1
need to install the foot rest
(Fig. O). Proceed as follows:
Installing the foot rest
Insert the tube end of the foot rest
the first loop from the side.
18
Insert the opposite end through the second
loop until both are in the middle of the
18
board .
1
standing up or
1
as an additional
9
to your ankle in
9
1
as shown in figure G:
to the rear D-ring
9 1c
through the
9b
through the loop on
9a
in
1
to the
9
and the seat
17 15
:
17
through
17
GB/IE
.
27