Publicité
Les langues disponibles
Les langues disponibles
Double leaf gate systems
1 - Unscrew fastening screws from upper
cover and remove the cover from
TOUCH EN12978 (Pic. 2 - particular
1).
2 - Unscrew fastening screws from lower
cover and remove the cover from
TOUCH EN12978 (Pic. 2 - particular
2).
3 - Mark the upper side (S) of the fastening
slot on the side of the aluminium profile
(Pic. 2 - particular 3).
4 - Position the safety strip in its proposed
working position. In case of vertical
mounting, keep a minimum distance
of 30 mm from the ground (Pic. 2 -
particular 2).
5 - Drill a hole in the wall at about 7
mm below the reference point and fix
the spring with opportune screws for
metal or wall anchor screws (Pic. 2
- particular 4).
6 - Position TOUCH EN12978 on the
spring and secure it in place by pulling
downward.
7 - Mark the holes to be drilled in the
wall in correspondence with -C- and
-D- (Pic. 2 - particulars 1 and 2).
8 - Remove the profile and drill the holes
as indicated into the step above.
Overhead door systems
Sectional door systems
(the same for rolling shutter
doors)
Possible positioning
Sliding gate systems
Sliding door systems
G
B
1
2
Publicité
