S.P.E. TORO1000 Manuel Utilisateur page 10

MANUALE UTENTE TORO1000
VISUAL SIGNALS
Power supply from Mains only
Charging Phase 1
Phase 2 or subsequent
Charge end or Equalization OFF
Equalization ON
Failure
Where: OFF = Led off
ON = LED permanently on
BL = LED blinking
Blink = number of blinks of LED
OPERATION
Once all connections are made, charging occurs automatically and the charge cycle will be determined by the type of
battery (if Pb, GEL or AGM), by its capacity (Ah) and its degree of discharge.
NOTES
- The battery charger can perform one charging profile only, which is the one stored inside it.
- Should it be necessary to vary the charging profile, you will need the sfw to access the battery charger
programming Consult the Assistance Service
SPE Elettronica Industriale di Poletti Sergio
Headquarter: Via di Mezzo Ponente, 383/B
40014 Crevalcore (Bologna) Italy
Messages reported RED LED YELLOW LED
OFF
OFF
OFF
OFF
ON
OFF
OFF
OFF
Blink
pag. 10/26
Rev n° 1 del 11/06/2024
GREEN LED
OFF OFF
OFF 3 x Blink (24V)
OFF 4 x Blink (36V)
OFF 5 xBlink (48V)
OFF OFF
ON OFF
OFF ON
OFF BL
OFF OFF