mundoclima MUPR-H14X Manuel D'installation page 110

Silence function
2s
Keep pressing Fan button for more than 2 seconds to activate/disable Silence
function.
Due to low frequency operation of compressor, it may result in insufficient cooling
and heating capacity. Press ON/OFF, Mode, Sleep, Turbo or Clean button while
operating will cancel silence function.
FP function
Press this button 2 times during one second under HEAT Mode and setting temperature of
16 C/60 F or 20 C/68 F (for model RG10A10(F2S/H2S/G2S)/BGEF). O
O O
O
2
The unit will operate at high fan speed (while
compressor on) with temperature automatically
set to 8 C/46 F.
Note: This function is for heat pump air conditioner only.
Press this button 2 times during one second under HEAT Mode and setting temperature of
16 C/60 F or 20 C/68 F (for model RG10A10(F2S/H2S/G2S)/BGEF) to activate FP function.
Press On/Off, Sleep, Mode, Fan and Temp. button while operating will cancel this function.
LOCK function
5s
+
Clean
Turbo
ECO Intelligent Eye Function
Press this button
Under ECO Intelligent eye mode, with the built-in infrared sensor, the unit
can detect
you are away for 30 minutes, the unit automatically lowers the frequency to save
energy (for inverter models only).
operation if sensing human activity again.
Press this button
Under Intelligent eye mode, with the built-in infrared sensor, the unit
can detect
people, but also can follow people.In Cooling and heating mode ,when you are away
for 30 minutes, the unit automatically lowers the frequency to save energy(for inverter
models only).
human activity again.
For details, please see " Intelligent Eye operation " in "Owner's Manual &
Installation Manual" .
5s
Press together Clean button and Turbo button at the
same time more than 5 seconds to activate Lock function.
All buttons will not response except pressing these two
buttons for two seconds again to disable locking.
the people's activities in the room. In Cooling and heating mode ,when
the people's activities in the room. The wind can flow away from
And the unit will automatically resume operation if sensing
And the unit will automatically resume
110