mundoclima MUPR-H14X Manuel D'installation page 102

Buttons and Functions
Before you begin using your new air conditioner, make sure to familiarize yourself with its remote
control. The following is a brief introduction to the remote control itself. For instructions on how to
operate your air conditioner, refer to the How to Use Basic Functions
ON/OFF
Turns the unit on or off.
TEMP
Increases temperature in
0.5°C (1°F) increments.
Max. temperature is
30°C (86°F).
NOTE: Press together
buttons at the same time
for 3 seconds will alternate
the temperature display
between the °C & °F.
SET
Scrolls through operation
functions as follows:
Breeze away( )
 Active
clean( ) Fresh/UV-C

lamp( )
Sleep(

Follow Me( )
AP

mode ( ) Breeze away...

The selected symbol will
flash on the display area,
press the OK button to
confirm.
TEMP
Decreases temperature
in 0.5 C(1 F) increments.
O O
Min. temperature is
16 C(60 F).
O O
FAN SPEED
Selects fan speeds in the
following order: AU
 20%
40% 60% 80% 100%.

  
Press the TEMP or
to increase/decrease the fan
speed in 1% increments.
SWING
Starts and stops the horizontal
louver movement. Hold down
for 2 seconds to initiate vertical
louver auto swing feature.
&
)

button
RG10L5(G2HS)/BGEF
Model:
Note: Used in MUPR-H14X series
section of this manual.
MODE
Scrolls through operation modes
as follows: AUTO  COOL 
DRY  HEAT  FAN
NOTE: HEAT mode is not supported
by the cooling only appliance.
Eco Intelligent eye
Used to detect the people
activities in the room to save
energy.
OK
Used to confirm the selected functions.
TIMER
Set timer to turn unit on or off
ECO/GEAR
Press this button to enter the
energy efficient mode in a
sequence of following:
ECO
GEAR(50%)
mode
HUMIDITY
Adjust the room humidity during
Dry operation in a range of
35%~85%. Press this button to
increase the humidity in 5%
increments.
NOTE: After setting, the humidity
settings will display on the screen.
LED
urns indoor unit's LED display
and air conditioner buzzer on
and off, which create a comfortable
and quiet environment.
TURBO
Enables unit to reach preset
temperature in shortest possible time.
Keep pressing this button more than 5
seconds in heating mode to active
Fireplace operation. To stop this
feature, keep pressing this button
more than 3 seconds
102
GEAR(75%)
Previous setting
ECO......