Xerox Phaser 3450 Guide De Référence page 52

E. Fiche de sécurité du matériel (anglais seulement)
SECTION 6 - ACCIDENTAL RELEASE MEASURES
SPILL OR LEAK: Sweep up or vacuum spilled materials and carefully transfer into sealable
waste container. Sweep slowly to minimize generation of dust during clean up. If a vacuum is
used, the motor must be rated as dust tight. A conductive hose bonded to the machine should
be used to reduce static buildup. Clean up residue if necessary with soap and cold water. Wash
or dry clean garments after removing loose toner.
SECTION 7 - HANDLING AND STORAGE
HANDLING: No special precautions, when used as intended.
STORAGE: Avoid high temperatures.
SECTION 8 - EXPOSURE CONTROL - PERSONAL PROTECTION
No special personal protection indicated, when used as intended in Xerox Phaser Ò laser
printers.
THRESHOLD LIMIT VALUE (TLV): 10 mg/m3 (total dust)
PERMISSIBLE EXPOSURE LIMIT (PEL): 15 mg/m3 (total dust); 5 mg/m3 (respirable dust)
SHORT TERM EXPOSURE LIMIT (STEL): None established
CEILING LIMIT: None established
XEROX EXPOSURE LIMIT (XEL): 2.5 mg/m3 (total dust); 0.4 mg/m3 (respirable dust)
SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES
APPEARANCE/ODOR: Black powder/faint odor
BOILING POINT: Not applicable
SOLUBILITY IN WATER: Insoluble
EVAPORATION RATE: Not applicable
VAPOR DENSITY (Air = 1): Not applicable
VOLATILE: Not applicable
SOFTENING RANGE: Not available
MELTING POINT: Not available
Imprimante laser Phaser™ 3450
46