SilverCrest RHYTHM GO Instructions D'utilisation Et Consignes De Sécurité page 39

Step1: Turn on a loudspeaker which will then by default
be set as the "primary" device and then connected to the
playback device via Bluetooth first. A beep sound will emit
out and the LED
once connected successfully.
Step2: Press and hold for 2 seconds on the PartyPlay
button of the primary device until the signal tone sounds
8 ] [
emitted and LED
Step3: Press briefly the PartyPlay
device, the LED
white and a signal tone sounds will emit out once connected
successfully. You can now control synchronously by
playback device during Bluetooth playback mode.
To integrate additional speakers, the Partyplay
button
8 ] [
speakers. Make sure all the speakers must all be within
Bluetooth range approx.10m.
Press and hold the Partyplay
break the Partyplay pairing connection, the LED
the connected secondary/ additional units flash and a
signal tone sequence sounds.
˜ Cleaning
Switch the product off and remove all cables before
cleaning.
Only clean the outside of the product using a clean,
dry cloth for cleaning the product and never use any
corrosive liquids / abrasive cleaning agents. Use a
slightly moistened cloth and a mild cleaning agent to
remove stubborn dirt.
When cleaning the speaker, the USB cover should be
closed.
˜ Storage during non use
Store the product in a dry environment when not in use.
Protect it from dust and direct sunlight. The rechargeable
battery needs to be charged regularly.
will flashes white approx. every 5 sec
5 ] [
will stay on during PartyPlay pairing.
5 ] [
of the second speaker will breathing
5 ] [
must be pressed once on the additional
button of second
8 ] [
button again to
8 ] [
GB/IE
on
5 ] [
37