SilverCrest RHYTHM GO Instructions D'utilisation Et Consignes De Sécurité page 36

˜ Establishing a Bluetooth
Switch on the playback device and make sures its
Bluetooth
On the product press the
until the LED
sequence sounds. The product will now attempt to
connect to the playback device (e.g. smartphone or
computer).
The product identification on the playback device will be
"RHYTHM GO". On the playback device "ACCEPT" the
connection. Please note the requirements of the software
on the playback device.
Once the connection is made, the LED
once every 5 seconds.
The maximum range of the connection is approx. 10 m,
but this may be reduced due to the geometry of the
space (obstructing furniture, walls, etc.).
The playback device must support Bluetooth
5.3 otherwise you may not be able to use all the
functions.
˜ Functions of the buttons
Start a playlist on your playback device.
The product has 6 buttons and these control the
following functions:
Button
34 GB/IE
mode is on.
®
flashes white and a signal tone
5 ] [
Function
— Press to switch the product ON or OFF.
— Press briefly during playback to pause or
continue playback.
— In paired mode, press and hold for
approx. 2 seconds to change to pairing
mode to allow another communication
device to connect.
connection:
®
button for 2 seconds
7 ] [
5 ] [
flashes white
standard
®