V2 STARK6 Mode D'emploi page 15

EU DECLARATION OF CONFORMITY
AND DECLARATION OF
INCORPORATION OF PARTLY
COMPLETED MACHINE
Declaration in accordance with Directives: 2014/35/UE (LVD);
2014/30/UE (EMC); 2006/42/CE (MD) ANNEX II, PART B
The manufacturer V2 S.p.A., headquarters in Corso Principi di
Piemonte 65, 12035, Racconigi (CN), Italy
Under its sole responsibility hereby declares that:
the partly completed machinery model(s):
STARK6-24V, STARK6-230V
Description: electromechanical actuator for gates
• is intended to be installed on gates, to create a machine
according to the provisions of the Directive 2006/42/EC.
The machinery must not be put into service until the final
machinery into which it has to be incorporated has been
declared in conformity with the provisions of the Directive
2006/42/EC and 89/106/CE.
• is compliant with the applicable essential safety requirements
of the following Directives:
Machinery Directive 2006/42/EC (annex I, chapter 1)
Low Voltage Directive 2014/35/EU
Electromagnetic Compatibility Directive 2014/30/EU
Directive ROHS2 2011/65/CE
USE LIMITATIONS
Before installing the product, check
that the sizes and the weight of the
gate leaf are within the limits stated in
CHART 1.
kg - maximum gate leaf weight
m - maximum gate leaf length
m
WARNING
• Leaves exceeding 5 metres
should not be panelled.
• Solenoid latch required for 4 m
and above.
• Over 5 m, mechanical stops on
the ground are required.
The relevant technical documentation is available at the national
authorities' request after justifiable request to:
V2 S.p.A., Corso Principi di Piemonte 65, 12035, Racconigi (CN),
Italia
The person empowered to draw up the declaration and to provide
the technical documentation:
Sergio Biancheri
Legal representative of V2 S.p.A.
Racconigi 01/06/2019
CHART 1
800
700
600
500
400
300
200
100
0 1000
800
700
600
500
400
300
200
100
0 1000
- 13 -
2000 3000 4000
m
2000 3000 4000
m
STARK6-24V
5000 6000 7000
STARK6-230V
5000 6000 7000