Publicité
Les langues disponibles
Les langues disponibles
SAFETY TIPS (ELECTRICAL)
1) Never make adjustments with the power connected.
Always disconnect your pump from the electrical outlet
before beginning any service procedures.
2) Do not stand on wet fl oor when servicing.
3) Do not put your fi nger into the fuse socket - it could
be fatal.
SYMPTOM
Motor does not run
Motor hums but fl ow
reduced or none at all
Runs continuously
TROUBLESHOOTING
CAUSE
Blown fuse
Tripped circuit
Disconnected plug
Corroded plug
Tripped overload
Defective switch
Defective motor
Float-improper position
Impeller jammed
Plugged check valve
Partially blocked inlet
Line leak
Worn impeller
Defective motor
Plugged inlet
Defective switch
Float obstruction
Plugged check valve
4) Never remove the round pin from your plug; this is the
ground and is there for your safety.
CAUTION
A plugged pump inlet can be mistaken for a faulty switch.
If the pump runs continuously or for extended periods of
time between turn offs - First check for a partially plugged
inlet.
Replace fuse
Reset
Reinstall
Clean prongs
Allow pump to cool, investigate cause (jammed impeller)
Replace switch
Replace pump/repair
Check for freedom of movement
Remove bottom plate and clean.
Remove valve, clean or replace
Clean inlet
Repair
Replace pump/repair
Replace pump/repair
Clean inlet
Replace switch
Adjust position of pump
Remove valve, clean or replace
3
REMEDY
Publicité
