Brevi turbo t180sr Manuel D'utilisation Et D'entretien page 29

The servicing frequencies indicated in this manual are indicative
and refer to normal conditions of use. They may therefore vary
depending on the type of service, whether the environment is
dirty or not, seasonal factors, etc.
The servicing operations must obviously be carried out more
frequently in heavier duty service conditions.
5.1.1 BELT REPLACEMENT AND TENSION ADJUSTMENT
The belts are correctly tightened when they give max - mm
(Fig. ).
Proceed in the following way to replace the belts and adjust
their tension:
Loosen the screws on the gearbox support
CAUTION
Work on the nuts until the belts
have been tightened to the
correct degree
Tighten the nuts
Tighten the screws
Fit the casing back in position
and fasten it with the screws
If the belts are changed, they must
all be replaced with others of the
same size. This will ensure that the
transmission always operates in a
5.2 LUBRICATION
Lubrication of any machine with parts that turn and/or rub to-
gether is a vitally important task for the life and functionality of
the actual machine itself. Lubrication must therefore be carried
out systematically and at the required intervals. The frequen-
cies given refer to machine use in a normal environment. If this
machine is used in heavier duty conditions, it must naturally be
lubricated more frequently.
- 29 -
turbo t 180sr
Fig. 8