Brevi turbo t180sr Manuel D'utilisation Et D'entretien page 24

turbo t 180sr
Only clean and grease the driveline when the PTO is
and the ignition key removed from the tractor's ignition
switch.
Rest the driveline on its stand ( Fig. ) when not used.
Prolonged use of the machine can cause the overdrive
housing (5 Fig. ) and certain parts of the hydraulic circuit
to overheat. Do not touch these parts during and imme-
diately after using the machine since they could cause
burns.
Do not carry out servicing or cleaning operations unless
the PTO has been disengaged and the tractor engine
Periodically check to make sure that the nuts and bolts
are well torqued. Tighten them if necessary.
Place adequate supports under the machine as a precau-
tion when servicing or replacing the tines/blades with the
machine raised.
Before working on the cutting tools, detach the PTO,
make sure that the tines are at a standstill.
Use the recommended oils.
Spare parts must comply with the requirements establi-
shed by the Manufacturer. Only use genuine spare parts.
The safety decals must always be clearly visible. They
must be kept clean and replaced if they become illegible
(new ones can be obtained from the Manufacturer).
The instruction manual must be kept throughout the life
of the machine.
If the country in which the machine is used has noise
prevention laws, adapt to these provisions by using the
appropriate protections. The measured noise levels are
given in section «
Comply with the laws in force in the country where the
machine is used when it comes to using and disposing of
the products used to clean and service the machine. Also
comply with the instructions given by the manufacturer
of such products.
Comply with the anti-pollution laws in force in the coun-
try of use if the machine must be scrapped.
3 TRANSPORT AND HANDLING
3.1 TRANSPORT AND HANDLING
».
- 24 -
If the machine must be transported over a long distance, it can
be loaded on a truck or railway car. In this case, consult
for the weight and dimensions. This will allow you
to make sure that the machine can pass through tunnels or low
ground to the loading platform, use a crane with an adequate
carrying capacity and hook up the machine from the relative
lifting points indicated on the machine.
: make sure that the carrying capacity of
points for lifting are clearly visible and are marked by stickers.
Lift the machine with the utmost care and move it slowly without
jolting on to the truck or railway car.
Once the machine has been moved on to the truck or wagon,
make sure that it remains blocked in position.
by means of the pre-engineered points marked with the
«hook» decal, using well tightened ropes or chains suited
to its weight and able to prevent it from moving in any
way.
After having transported the machine to the desired site
and before removing the elements that hold it in place,
make sure that its position is unable to be of danger.
Now remove the ropes and unload the machine from the
means of transport in the same way as it was loaded.
CAUTION
CAUTION
-
-