Parker PSE Serie Manuel D'utilisation page 4

or components and/or options are fully comprehensive for the correct or foreseeable use of the machine
itself or its components.
Y
IMPORTANT: The manufacturer reserves the right to modify this manual at any time. The most
comprehensive and updated information, the user is advised to consult the manufacturer.
1.4 Residual risks
The installation, start up, stopping and maintenance of the machine must be performed in accordance
with the information and instructions given in the supplied technical documentation and always in such a
way to avoid the creation of a hazardous situation. The risks that it has not been possible to eliminate in
the design stage are listed in the following table:
Part affected Residual risk Manner of exposure
heat exchanger small cuts contact
coil
fan grill and fan lesions insertion of pointed objects
through the grill while the fan
is in operation
inside the unit: burns contact
compressor and
discharge pipe
inside the unit: intoxication, defects in the insulation of the
metal parts and electrical shock, power supply lines upstream
electrical wires serious burns of the electrical panel; live
metal parts
outside the unit: intoxication, fi re due to short circuit or
area surrounding serious burns overheating of the supply line
the unit upstream of the unit's electri-
cal panel
English
2 Introduction
This manual is in reference to refrigeration dryers designed to remove water vapor from compressed air.
2.1 Transportation
The packed unit must:
• remain upright;
• be protected against atmospheric agents;
• be protected against impacts.
2.2 Handling
Use a fork-lift truck suitable for the weight to be lifted, avoiding any type of impact.
Precautions
2.3 Inspection
avoid contact, wear protective
gloves
• All the units are assembled, wired, charged with refrigerant and oil and tested under standard oper-
do not poke objects of any type ating conditions in the factory;
through the fan grille or place • on receiving the machine check its condition: immediately notify the transport company in case of any
any objects on the grill damage;
• unpack the unit as close as possible to the place of installation.
avoid contact, wear protective
gloves
2.4 Storage
If several units have to stacked, follow the notes given on the packing. Keep the unit packed in a clean
adequate electrical protection
place protected from damp and bad weather.
of the power supply line; ensure
metal parts are properly con-
nected to earth
ensure conductor cross-sectional
areas and the supply line protec-
tion system conform to applicable
regulations
PSE 1400-6000 60Hz
2/14