Publicité
Les langues disponibles
Les langues disponibles
Displaying the Stored Value
Push the memory retrieve button
2 in order to display the value
stored in the memory. "M=" is
indicated in the display. When the
memory contents "M=" is
indicated in the display, it can be
doubled by pushing the memory
add button 3 or set to zero by
pushing the memory subtract
button 12.
The memorized values can only
be displayed in decimal feet
or meters.
The reception lens 22 and the
laser beam outlet 21 must not be
covered when taking
a measurement.
The rangefinder must not be
moved while taking a
measurement (with the exception
of the continuous measurement
mode). Therefore, whenever
possible, place the rangefinder
against or on the measuring
points.
Measurement takes place at the
center of the laser beam, even
when target surfaces are sighted
at an incline.
Operating Instructions
Deleting the Memory
To delete the memory contents,
first push the memory retrieve
button 2, so that "M=" is
indicated in the display. Then
push the clear button 14; "M" is
no longer indicated in the display.
The measuring range depends
upon the light conditions and the
reflection properties of the target
surface. For improved visibility of
the laser beam when working
outdoors and when the sunlight
is intense, use the laser viewing
glasses 25 and the laser target
plate 26, or shade off the
target surface.
When measuring against
transparent surfaces (e.g. glass,
water) or reflecting surfaces,
faulty measurements are
possible. Also, porous or
structured surfaces, air layers
-20-
Publicité
