Bosch GLR225 Consignes De Fonctionnement/Sécurité page 15

Area Measurement
For area measurements, push
button 5 until the indicator for
area measurement
appears in the display.
Afterwards, measure the length
and the width, one after another,
in the same manner as a length
measurement. The laser beam
remains switched on between
both measurements.
After taking the second
measurement, the area is
automatically calculated and
displayed. The last individual
measured value is indicated at
the bottom in the display, while
the final result is shown at
the top.
Volume Measurement
For volume measurements, push
button 5 until the indicator for
volume measurement
appears in the display.
Afterwards, measure the length,
width and the height, one after
another, in the same manner as
for a length measurement. The
laser beam remains switched on
between all three measurements.
After taking the third
measurement, the volume is
automatically calculated and
displayed. The last individual
measured value is indicated at
the bottom in the display, while
the final result is shown at
the top.
Values above 999990 ft
be displayed; "Error" and "- - - -"
appear on the display. In this
case, switch the unit of measure
to meters (see "Changing the
Unit of Measure", page 14).
Area or Volume Rounding of
Large Calculations
For values larger than 9999 feet
or meters the rangefinder rounds
the calculated value to the
nearest 10 feet or 10 meters.
Accuracy in such situations is
always 99.95% or better.
Minimum Measurement
(see figure F)
The minimum measurement is
used to determine the shortest
distance from a fixed reference
point. It is used, as an example,
for determining plumb lines or
horizontal partitions.
For minimum measurements,
press button 4 until "MIN"
appears in the display.
-15-
3
cannot