Publicité
Les langues disponibles
Les langues disponibles
wire welder or parts show any damage.
If this is the case, do not use the inverter
flux cored wire welder. Contact the
manufacturer via the indicated service
address.
Remove all protective films and other
„
transport packaging.
Check that the delivery is complete.
„
z Assembly
z Assembling the welding
protection shield
Insert the dark welding lens
„
writing facing up into the shield body
(see Fig. C). The labelling on the dark
21
welding lens
the front of the protective shield.
Push the handle
„
the corresponding notch of the mask,
until it snaps into place (see Fig. D).
z Inserting the flux cored wire
Always unplug the mains
plug from the mains socket prior to each
maintenance task or preparatory work in
order to prevent the risk of an electric shock,
injury or damage.
Note: Different welding wires will be
needed depending on the application.
Welding wires with a diameter of
0.6–1.0 mm can be used with this device.
Feed roll, welding nozzle and wire cross-
section must be compatible with one another.
The device is suitable for wire reels weighing
up to maximum 1000 g.
Unlock and open the cover of the wire
„
1
feed unit
by pushing the latch up.
Unlock the roll unit by pressing on the roll
„
holder
29
and turning it anticlockwise
(see fig. F).
Pull the roller holder
„
the shaft (see fig. F).
21
with the
must now be visible from
22
from the inside into
29
and washer off
Note: Make sure that the end of the wire
does not come loose and cause the roll to
roll out on its own. The end of the wire may
not be released until during assembly.
Completely unpack the flux cored wire
„
welding spool
without difficulty. Do not release the wire
end yet (see Fig. G).
Place the wire reel on the shaft. Make
„
sure that the roll unwinds on the side of
31
the
wire feed guide (see Fig. G).
Replace the washer and the roller holder
„
29
and lock them by pressing and
turning clockwise (see fig. G).
20
Undo the adjustment screw
„
it downwards (see Fig. H).
Turn the thrust roller unit
„
(see Fig. I).
Loosen the feed roll holder
„
it anti-clockwise and pull it forwards and
off (see Fig. J).
On the top of the feed roll
„
whether the appropriate wire thickness is
indicated. If necessary, the feed roll has to
be turned over or replaced. The supplied
welding wire (Ø 0.9 mm) must be used
in the feed roll
thickness of Ø 0.9 mm. The wire must be
positioned in the front groove!
Erect the feed roll holder
„
screw in a clockwise direction.
Remove the burner nozzle
„
it anti-clockwise (see Fig. K).
Unscrew the welding nozzle
„
(see Fig. K).
Guide the cable assembly
„
away from the welder as straight as
possible (place it on the floor).
Take the wire end out of the edge of the
„
spool (see Fig. L).
Trim the wire end with wire scissors or
„
a diagonal cutter in order to remove the
damaged, bent ends of the wire
(see Fig. L).
Note: The wire must be kept under
tension the entire time in order to avoid
a releasing and a roll out! Therefore it is
17
, so that it can unrolled
27
and swing
28
to the side
30
by turning
19
, check
19
with the specified wire
30
again and
9
by turning
15
12
GB/IE/NI
17
Publicité
