Publicité
Les langues disponibles
Les langues disponibles
OPERATING AND MAINTENANCE MANUAL
SOLAR PUMPING GROUP
5.2 Instruction button
Botón
The pump will start running immediately, without delay of 1 minute when the power
"Start"
"V/A/P"
"n/E/h"
Displays system parameters sequentially, speed / fault code / system run time
"Stop"
5.3 Digital manual display
Digital exhibitions
The decimal points are illuminated
in a successive, circular pattern.
"N" is shown on the display
"U XXX" is displayed on the screen
"P XXX" is displayed on the screen
"C XX.X" is displayed on the
screen.
"C XX.X" is displayed on the
screen.
"XXXX" is displayed on the screen
"E-XXX" is displayed on the
screen.
"X" is displayed on the screen
"N XXX" is displayed on the screen
www.proindecsa.com / proindecsa@proindecsa.com
Displays system parameters sequentially, voltage / current / power
Stop the pump immediately, and the pump must be restarted manually.
1. When in operation, the system enters the default power-
saving mode.
2. After 1 minute of inactivity, the system enters the power-
saving model.
Press the "START" button and you will enter the start mode.
The first time you press the "V / A / P" button, and it will
display the system voltage.
The third time you press the "V / A / P" button, and it will
display the engine power.
The second time you press the "V / A / P" button, and it will
display the current overload.
The second time you press the "V / A / P" button, and it will
display the current overload.
The first time you press the "n / E / h" button and a number
is shown on the display. Calculate the speed of the motor
according to this number. Speed = number pairs / poles (note:
pole pairs = number of poles / 2).
Error log (more details refer to the error code)
Display engine running time
Press the "STOP" button to enter stop mode.
Instruction
is switched on.
Instruction
43
Publicité
