emerio CBC-122043.2 Mode D'emploi page 10

2. Cancel the timer settings
1) Cancel all the timer settings.
Press the button "WEEK" for approx. 3 seconds until the LED display shows the flashing "UU".
Long press the button "C" until a beep sound is heard. It means all the timer settings are cancelled.
2) Cancel all timer settings of a specific day.
Press the button "WEEK" for approx. 3 seconds until the LED display shows the flashing "UU".
Press the button "SET" consecutively until the LED display shows the flashing "U1" (day 1, for
example).
Press the button "+" / "-" to select the day for which you want to cancel the timer settings.
Long press the button "C" until a beep sound is heard. It means all the timer settings of the day are
cancelled.
3) Cancel a specific timer setting.
Press the button "WEEK" for approx. 3 seconds until the LED display shows the flashing "UU".
Press the button "SET" consecutively until the LED display shows the flashing "U1" (day 1, for
example).
Press the button "+" / "-" to select the day for which you want to cancel the timer setting.
Press the button "ED".
Press the button "+" / "-" to select the number of the timer setting that you want to cancel.
Long press the button "C" until a beep sound is heard. It means this timer setting is cancelled.
3. Check the timer settings
Press the button "WEEK" consecutively. You will see the following settings in sequence:
- Timer on (ON) or timer off (OF)
- Once only (01) or repeatedly (99)
- U1-U7, day of the week
- Timer setting number of the day concerned (01, 02, 03 or 04)
- The set temperature
- Start time in hours
- Stop time in hours
All 28 timer settings are shown, also the timer settings that have not been filled. The temperature of the
non-filled timer settings is 20 °C.
Open-window detection function
Press the open-window detection button on the remote control. The open-window detection symbol will
appear on the LED display. If the ambient temperature decreases 8℃ or more within 15 minutes, the heater
will turn off and the related symbol will flash. If this is the case and you press the button again, the heater will
resume its normal operation. Note: after Wi-Fi connection, this function is invalid.
ECO function
This appliance is equipped with the ECO function. If the button "ECO" is pressed, the LED display will show "EC".
The appliance will start to heat if the ambient temperature drops to below 16℃ and will turn off if the
ambient temperature increases to above 16℃. Press the button "ECO" again to switch off the ECO function.
- 9 -