emerio CBC-122043.2 Mode D'emploi page 15

SAFETY FEATURE
In case of internal overheating, the overheating safeguard will switch the heater off. This may occur if the
heater cannot give off enough heat or if it cannot draw in enough fresh air. As mentioned above, this is
generally caused by (partially) covering the heater, or installing the heater too close to a wall or something
similar. In case of overheating, switch off the heater and unplug. Give the heater time to cool down, remove
the source of the overheating and use as normal. If the problem persists or if you have not been able to trace
the source of the overheating, turn the heater off immediately and unplug. Contact a servicing support to have
the heater repaired.
CLEANING AND MAINTENANCE
Keep the heater clean. Switch off the heater, remove the plug from the socket and allow the heater to cool
down before cleaning or carrying out maintenance work.

Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do not use aggressive soaps,
sprays, cleaners or abrasives, waxes, polishes or chemical solutions which can cause irreparable scratches
and damage! You can keep the back of the heater free of dust with a feather duster. For thorough cleaning
of the back, you can take the heater from the wall.

If you want to store the heater at the end of the season, remove it from the wall, unscrew the wall
mounting bracket and store the entire unit (in the original packaging) upright in a cool, dry and frost-free
place.
TECHNICAL DATA:
Operating voltage: 230V ~ 50-60Hz
Power consumption: 720W
- 14 -