emerio CBC-122043.2 Mode D'emploi page 6

Please take below minimum distance picture (fig.1) for reference.
Please pay attention to fig.2: The wall-mounting system (A & B) on the rear side of the appliance should be
pre-mounted in order to hang it vertically. Viewed from the front, the power switch is at the bottom side and
the control panel is at the right-hand side.
A. Wall mounting bracket & knobs
B. Wall spacer (Bracket for keeping space from the appliance to the wall)
Note: The knobs and wall spacer have already been installed on the rear side by the factory.
Please install the wall mounting bracket by following steps.
1. Choose a firm, even, vertical wall made of heat-resistant material on which to hang the appliance.
2. Define the position of the wall mounting bracket: the bracket should be mounted horizontal to the wall.
Position the bracket in such a manner that the minimum distances stated in fig.1 are guaranteed after the
appliance is mounted to the wall. Mount the bracket with the correct side upwards (see the mark "This
side up" on the bracket).
3. Mark the positions of the four holes to be drilled on the wall.
4. Drill 10mm holes in the marked places.
5. Insert the bolts (A&B) into the holes with a hammer. Put on the wall bracket. Secure the wall bracket
immovably against the wall by using the washer (C), gasket (D) and nut (E).
(fig.1)

Holes

Bolts

Wall mounting bracket
- 5 -
A
B
(fig.2)