CubCadet Ultima ZTS Serie Manuel De L'utilisateur page 8

NOTE: This Operator's Manual covers several models. Tractor
features may vary by model. Not all features in this manual are
applicable to all tractor models and the tractor depicted may
differ from yours.
NOTE: All references in this manual to the left or right side and
front or back of the tractor are from the operating position only.
Exceptions, if any, will be specified.
PREPARATION
Remove the deck wash system nozzle adapter (if equipped) from
the manual bag, store for future use.
Manually Moving the Tractor
1. To engage the transmission bypass, pull the transmission
bypass lever (a) located to the right of the operator's seat
(next to the park brake lever (b)), back and into the notch on
the right side of the slot (Figure 1).
b
Figure 1
2. After moving tractor, reverse Step 1 to disengage the
transmission bypass.
Install Hitch (if necessary)
1. Locate hitch (a) and install on the rear of the frame using the
two hex washer screws (b) provided (Figure 2).
b
a
Figure 2
NOTE: Hitch and hex washer screws will be in the hardware pack.
SET-UP
a
b
8
Reposition Upper Hoop (if necessary)
Upper hoop may be positioned down for shipping purposes:
1. Remove the two hex washer screws (a) partially installed on
the frame (Figure 3).
b
b
Figure 3
2. Rotate the upper hoop (b) into position (Figure 3).
3. Secure hoop in place with the hex washer screws removed
in Step 1. Torque the hex washer screws to 159-239 in-lbs
(18-27 N-m).
Install Operator's Seat (if necessary)
1. Remove any straps securing the seat assembly to the tractor.
Remove all packing material.
NOTE: Be careful not to cut the seat wiring harness.
2. Install the seat onto the seat pan (c) using hardware provided
(Figure 4).
b
b
a
a
a
a
Figure 4
a. Use flange lock nuts (a) and flat washers (b) (Figure 4).
a
c